BHD
JOD
KWD
LBP
OMR
QAR
SAR
USD
Ultimate Ears UE 11 PRO by Adam Rhodes Custom Ears
UE11 PRO - For those who need low end this earphone is incredible!
4 drivers. 2 balanced armatures dedicated to the lower frequencies, the UE 11 PRO delivers tight and accurate bass. Perfect for audiophiles that want low end, bass players, drummers, and DJ's.
Better Bass
4 proprietary balanced armatures tuned to enhance the low frequencies.
Precision Tuning
An integrated 3-way crossover turns the sub on only when it’s needed.
Tech Specs
- Input sensitivity:
119 dB @ 1 kHz, 1mW - Frequency response:
5 Hz – 22 kHz - Noise Isolation:
-26 decibels of ambient stage noise. - Impedance:
18 Ohms@ 1 kHz
- Internal speaker configuration:
4 proprietary balanced armatures with a 3-way crossover. - Input connector:
1/8” headphone jack; compatible with all systems - Warranty:
1-year
Recommended Products
Prepaid Product
Customer Also Viewed
Samma3a Review
Technical Specification
What Is In The Box
Videos
Manufacture Description
Adam Rhodes has over 11 years experience fitting and providing custom in-ear monitors (CIEMs) and hearing protection for audiophiles, musicians and celebrities in the US and UK.
CIEMs have been used mostly by musicians in the past and can be cumbersome for consumers to purchase. But with the introduction of a wide product range for consumers, bluetooth capability and 3D ear scanning technology, audiophiles and consumers now have the same accessibilty to the best earphones money can buy.
Adam Rhodes, now based in Dubai, is bringing the world's best CIEMs and earplugs to the GCC and Middle East and will guide you through the entire process of going custom and save you time and answer any questions you may have.
Customer's located in Dubai & Abu Dhabi: Adam will contact you to schedule ear impressions either at his office in JLT, or an agreed location. From there, Adam will 3D scan the ear impressions to STL files and email to the chosen manufacturer.
Customer's located outside of Dubai & Abu Dhabi: Adam will help secure ear impressions at a local audiologist to you, ensuring they follow the standard required for ear impressions. Then Adam will arrange for the impressions to be sent to him for 3D scanning, conversion to STL files and emailed to the chosen manufacturer.